Beautiful coloured two part busks for corsetry. The perfect match for many of our gorgeous fabrics.
Coated for us by the lovely Nikki at Narrowed Visions.
Available in lengths from 28cm to 32cm
Flexible two part busks to fasten the front of corsets.Some flex but still supportive, these are uncoated but with dipped ends. Measure 13mm wide each side. Top European quality.
POWDER COATING FAQ
Q: Will the coating chip?
A: There is currently no way to coat metal (especially stainless steel) that will not chip or wear under the right circumstances. However powder coating is extremely hardwearing and will resist chipping if it is handled correctly.
Q: What are these marks and will they affect the coating?
A: Some marks are caused by the wire used to hang the busk. Sometimes, either due to the busk being slightly off centre or a slight relaxation of the hook during curing, the powder on the busk comes into contact with the powder on the hooks. When the busk is cured (heated in the oven) the powder flows over both and so the hook must be separated from the busk manually. This mark will not affect the performance of the powder coating and will not be visible when the busk is in use. If you are concerned about any rough edges then a nail file can be used to smooth out the mark.
Q: Why are there holes in the ends of the busk
A: These holes allow the busk to be hung during the coating and curing process. They also keep any marks (that can be caused by the hanging wire) on the part of the busk that will not be seen during its normal use.
Our Price (inc VAT):
Spiral Wire on rolls, just add end to make your own custom sized wires.
Our Price From: £3.30
Classic two part busk powder coated to gorgous jet black.
Our Price From: £9.29
Distinctive rosebud fabric for corsetry and costume
Our Price From: £24.60
Classic 2 part steel corset busk with silver clasps
Our Price From: £7.25
Cotton Corset laces with silver metal aglets (end tags)
Our Price From: £3.28
End Caps for finishing your own spiral wires
Our Price From: £3.97
Please fill in the following form to contact us.